Description
Linear (GTO) PRO SW3200XLS – Secondary Arm Only | GTO-PRO-SW3200XLS
Linear (GTO) PRO SW3200XLS – Secondary Arm Only | GTO-PRO-SW3200XLS
The Linear (GTO) PRO SW3200XLS series will operate a gate up to 16 ft. (4.9 m) long and weighing 650 lbs. (294.8 kg) each leaf if all proper installation procedures have been followed. Ball bearing hinges should be used on all gates weighing over 250 lbs. (113.4 kg).
Includes
- Battery backup
- 318 MHz radio receiver
- Entry transmitter
- AC transformer
- All necessary mounting hardware for a post mounted installation, 16˝ (40.6 cm) total offset
Features
- One button auto-memorization of digital transmitter code
Electrical
- 12 Volt DC / 7.0 amp hour, sealed, rechargeable battery (included). Battery charge is maintained by a 120V AC/60 Hz input, 18V AC, 40 VA. output, transformer rectified to 14V DC through a control board
- Powered by a reliable 12 Volt (120 Watt) DC motor, 16:1 planetary gear drive system
- Charging regulated circuit on control board. “Sleep draw” is 15 mA; “active draw” is 3 to 7 amps
Mechanical
- The LINEAR (GTO)® control board can be programmed for pull-to-open or push-to-open
- Operating temp -5 F (-21C) to +160 F (71 C)
- Opening time: From 15 to 18 seconds
- Range of arm stroke: is up to 16˝ (41 cm)
- Operator length: with arm fully retracted is 40.25˝ (102 cm), mounting point to mounting point
- Operation, diagnostic and safety alarms
- Inherent obstruction sensing
- Soft start/soft stop—for long mechanical life expectancy
- Auto close adjustable 3–120 seconds delay
Product Literature
- Linear PRO-SW3200XLS Product Brochure
- Linear PRO-SW3200XLS Dual Installation Manual
- Linear PRO-SW3200XLS Single Installation Manual
